
PioneroSL is modified version of Pionero 4 that allows you to modify system loader of 1630.
You only need to use it once to be able to load 1,25Mb firmwares on your Pioneer 1630.
Usage is same as original Pionero.

- Unpack PioneroSL folder on your harddisk.
- Connect dec with serial and parallel cables (usual procedure)
- Put box in service mode shorting to ground point K2002 of youm motherboard (usual procedure).
- Go to Firmware(Parallel+Serial) page.
  - Check that address is 7FF60000
  - Check that Command Option box is set to SL(K2002)
  - Press Send Button -> select file 1630_7FF60000_MOD.bin in folder
  - check that transmission has completed successfully (Dl2o  on decoder display) 

Once the file is loaded: 
- close PioneroSL
- Reset the dec again in service mode
- Open a normal Pionero Version to load a 1630 (FULL ) firm using normal procedure

If you want to return to original (or lite) firmwares just repeat perocedure sending 1630_7FF60000_ORIG.bin to the same address.

enjoy
Bobbejaans/Dreadlock


MANY THANKS TO ldnlp FOR THIS LONG AWAITED POSSIBILITY.
Thanks of course to Sa1vad0r and those who contributed Pionero.
